Lightspeed Redcat

To Next Page

STANDARD REGISTRATION

FLEXMIKE REGISTRATION (OTHER REGISTERED COMPONENTS IN PLACE)

(Particularly valuable when Redcat Access is mounted on the wall)

For users adding a second Flexmike or replacing a lost or malfunctioning Flexmike.

1. Start with the Redcat plugged in and powered on.

2. If replacing a Flexmike, make sure the malfunctioning Flexmike is powered o.

3. If a second Flexmike, Sharemike or Media Connector is present, power it on and wait until it

has a solid blue light (“Ready”). (For the purpose of these instructions, it is assumed that the

#1 Flexmike is the functioning Flexmike and we are registering the #2 Flexmike.)

4. Power on the new Flexmike. Both microphone 1 and 2 blue lights should start

blinking.

10. Place system ID number (attached to the Redcat Quickstart Guide) on the new

Flexmike.

NOTE: if at any point, the Redcat or Flexmike lights begin blinking rapidly, that

indicates a registration error. Turn the new Flexmike o and repeat steps 4-9.

Power On

Solid light

(Existing Good Flexmike)

5. Open the new Flexmike battery compartment and pull the battery out (leaving it

plugged in) to reveal the registration button.

6. Use another registered functional component (existing Flexmike, Sharemike or

Media Connector) to trigger the registration function in Redcat.

• Using a paperclip with the end straightened out, press and hold the registration

button for 3 seconds inside the functioning Flexmike. This triggers registration in

the Redcat and the Redcat’s 1 and 2 amber lights will begin blinking.

• If using a registered Sharemike or Media Connector to trigger the registration

function, this process remains the same.

7. Briefly press the registration button on the new or replacement Flexmike. The 1

and 2 blue lights will start blinking alternately.

8. Aer several seconds, the 2 light on the Redcat will turn solid and the 2 light on the Flexmike will remain blinking, then turn solid.

9. The registration is complete. You can begin speaking into the new Flexmike to verify there is audio.

1POWER 2

Solid lights

1POWER 2

Blinking lights

Power On

Blinking lights

(NEW Flexmike)

Registration

Button

SYSTEM ID#

RETAIN EXTRA LABELS IN THE EVENT A COMPONENT IS REPLACED OR ADDED.

Match components

to this system ID#

Apply to system components to indicate which parts are registered

as a system. Keep registered items together when storing away.

Registration ID Labels

00-01

334-0162-02-00-01

10101

AUDIO IN

MIN

MAX

AUDIO

(ALD) OUT

MIN

MAX

ON/OFF

DC INPUT

16V/2.0A

REDCAT ACCESS REGISTRATION GUIDE

Lightspeed Redcat - Manual

Other manuals for Lightspeed Redcat

Related product manuals