Lightspeed Topcat LSRCNG - Pairing Topcat to Media Connector; Topcat and Media Connector Pairing Process

26
Pairing Topcat to Media Connector
SET-UP & DAILY OPERATION
FLEXMIKE
From a powered o state, point
the IR transmitter lens toward
the Topcat (for Sharemike, the
transmitter lens is located on
the back of the microphone).
1
Press and hold the Flexmike
power button for 5 seconds until
the mic 1 and mic 2 lights start
flashing, then release the button.
At this point, the status light on
Topcat will blink for 30 seconds.
If aer 30 seconds the status light
blinks rapidly, you will need to
start the pairing process again.
2
With the Media Connector
powered o, press and hold
the power button to put it into
pairing mode.
When the status lights are solid
on both Topcat and Media
Connector, pairing is successful.
3
Audio
Input
Audio
Output
Tone
Level
Push
StatusPower
Media Connector
STATUS LIGHT
STATUS LIGHT
TOPCAT
MEDIA CONNECTOR
MIC 2
MIC 1
POWER
IR TRANSMITTER
(Optional)
Your system is shipped with microphones and base units pre-paired for quick and easy use.
If, for any reason, you need to pair new components, follow this pairing process: