-8-
How to Activate Connection in the AP Mode
1. Use a Wi-Fi enabled computer or smartphone to configure the Wi-
Fi IPCAM.
2. Search for a Wi-Fi IPCAM with an SSID of “IPCam-the last 6 digits
of MAC.” E.g., Wi-Fi MAC = 00-0F-FC-57-49-74, SSID = IPCam-
574974
3. A password is required to connect to the Wi-Fi IPCAM. The default
password is pass1234.
4. When connected, the default IP address of the AP mode is
192.168.15.1. You can use an Internet browser to change Wi-Fi
settings with this IP address.
Emergency Factory Default
To restore the hardware to factory default settings, please follow
these steps:
1. Press and hold “RESET Key” for 10 seconds and release.
2. Wait for about 40 seconds, and the network LED light should turn
off, and go back on again.
3. The camera is now restored to factory default settings, and will
reboot automatically.
4. Search for the IP device using the IPScan software.
5. Start the IP device via an Internet browser.
6. Enter the default username “admin” and password “pass” to
operate.
NOTE: For your convenience, the IP address will revert to the default
setting of 192.168.0.200.
To Next Page
Loading...