Lilytech ZL-620A-R - Control Function Description; Compressor Control; Compressor Delay Protection; Fan Control

10 U33 Dripping water time
0～180min
5
11 U34
Over temperature warning delay time
after defrost ends
0~180 hour 0: Disable 2
12 U35 Defrost when the device starts 0~1
0: Disable
1:Enable
0
13 U36
Defrost delay time when the device
start
0～180min
0: Disable 0
14 U40 Fan start temperature
-45～+120℃
-10
15 U41 Fan start-up delay
0～600sec
60
16 U42 Fan stop delay
0～600sec
0
17 U43 Fan mode
0～1
0: Controlled
1: Free mode
0
18 U50
High-temperature warning deviation
value to Max Temp
0~60℃ 0: Disable 0
19 U51
Low-temperature warning deviation
value to Min Temp
0~60℃ 0: Disable 0
20 U52 Over-temperature warning delay time
1～180min
30
21 U53
First over-temperature warning delay
time after power supply
0~180 hour 0: Disable 2
22 U60 External input warning mode 0~4
0:Warning off
1:On, Lock
2:On, Unlock
3:Off, Lock
4:Off, Unlock
0
23 U61
External warning input delay
0~120min 0
24 U62 Buzzer warning 0~1
0:Warning off
1:Warning on
25 U97 Baud rate setting 0 ~ 3
0: 2400bps
1: 4800bps
2: 9600bps
3: 19200bps
3
26 U98 Device address 1 ~ 99 ---- 1
27 U99 Password 0000~9999 1111
28 End Finished setting
7. Control Function Description
7.1 Compressor Control
● When the temperature “Set temperature”+”U22”, and the compressor has stopped for ≧
“U10”, the compressor starts.
● When the temperature “Set temperature”≦ -”U22”, and the compressor has run for “U11”,