Lincoln Electric VIKING 2450 Series User Manual (English)

Questions and Answers:

J
Janet DaltonJul 28, 2025
What to do if the filter of my Lincoln Electric VIKING 2450 doesn't darken when welding?
- T
  Teresa GrahamJul 28, 2025
  If your Lincoln Electric Motorcycle Accessories filter does not darken when an arc is struck, there might be several reasons: * The sensitivity might be set too low. In this case, you should adjust the sensitivity to the required level. * The front cover lens could be dirty. Clean or replace the front cover lens. * The front cover lens might be damaged. Check for cracks or pitting and replace it as needed. * The sensors or solar panel might be blocked. Ensure that you are not blocking the sensors or solar panels while welding and adjust your position. * Grind Mode might be selected. Ensure that the proper shade is selected.
H
Hannah GonzalezAug 2, 2025
How to improve visibility through the filter of Lincoln Electric VIKING 2450 Motorcycle Accessories?
- D
  Dana CampbellAug 2, 2025
  If you are finding it difficult to see through the filter of your Lincoln Electric Motorcycle Accessories, it could be due to a dirty front cover lens or a dirty cartridge. Try cleaning or replacing the front cover lens. Also, clean the auto-darkening cartridge with a soapy water solution and a soft cloth.
D
daniel58Aug 7, 2025
Why is the filter of my Lincoln Electric Motorcycle Accessories darkening without welding?
- T
  tsuttonAug 7, 2025
  If your Lincoln Electric Motorcycle Accessories filter is darkening without an arc being struck, the sensitivity might be set too high. Adjust the sensitivity to the required level.
L
Lauren CowanAug 12, 2025
What to do if my Lincoln Electric VIKING 2450 Motorcycle Accessories helmet won't switch to grind mode?
- J
  Jessica MooneyAug 12, 2025
  If the helmet of your Lincoln Electric Motorcycle Accessories will not switch to grind mode after pressing the button, it could be due to the button not being held for 3 seconds. Press and hold the button for 3 seconds. Alternatively, the plug-in jack from the filter might not be completely inserted in the button port. Remove the plug-in jack from the button port and re-insert it.
A
amurphyAug 17, 2025
Why does the filter of my Lincoln Electric VIKING 2450 stay dark after welding?
- D
  danielle63Aug 17, 2025
  If the filter of your Lincoln Electric Motorcycle Accessories remains dark after completing a weld, the delay time might be set too high. Adjust the delay time to the required level.
J
joseph25Aug 22, 2025
How to fix a cracked ADF or weld spatter damaging the filter on Lincoln Electric Motorcycle Accessories?
- M
  Matthew WilliamsAug 22, 2025
  If the ADF of your Lincoln Electric Motorcycle Accessories is cracked or weld spatter is damaging the filter, it is likely due to a missing, damaged, broken, cracked, or distorted front cover lens. Replace the front cover lens as needed.