6. Remove the lug wrench and jack from
the foam holder.
7. Block the diagonally opposite wheel.
8. Loosen each wheel lug nut one-half
turn counterclockwise but do not
remove them until the wheel is raised
off the ground.
9. The vehicle jacking points are shown
here, and are depicted on the yellow
warning label on the jack. Note: Jack
at the specified locations to avoid
damage to the vehicle.
10. Small arrow-shaped marks on the sills
show the location of the jacking
points.
11. Remove the lug nuts with the lug
wrench.
12. Replace the flat tire with the spare
tire, making sure the valve stem is
facing outward. Reinstall the lug nuts
until the wheel is snug against the
hub. Do not fully tighten the lug nuts
until the wheel has been lowered.
13. Lower the wheel by turning the jack
handle counterclockwise.
303
MKZ (CC9) , enUSA
Wheels and Tires
To Next Page
Loading...
