Lincoln 3665 - Assembly; Operation

Assembly
1 Refer to figure 1 and place the handle (3)
into the bracket mounting slot (6).
2 Align holes of the handle (3) and the
mounting bracket (6).
3 Insert the bolts (5) thru the holes of the
mounting bracket (6) and into the holes of
the handle (3).
4 Tighten both bolts (5).
5 *Refer to figure 1 and slide hose clamp
(8) over end of evacuator hose (4).
6 Connect the end of the evacuator hose (4)
to barbed fitting assembly (7) under the
reservoir (1).
7 Place hose clamp (8) over barbed fitting
assembly (7) and evacuator hose (4).
8 Tighten the hose clamp (8).
Fig. 1
Operation
1 Inspect drain for damage.
2 Place reservoir (1) under vehicle.
3 Remove the oil drain plug from the
vehicle’s engine.
4 Allow all engine oil to drain from the
engine and into the reservoir (1).
5 Replace the vehicle’s drain plug.
6 Move the reservoir (1) to a temporary
storage area.
7 Attach the evacuator hose (4) to a
vacuum pump.
8 Pump the oil from the reservoir (1).
9 After all oil has been drained from the
reservoir (1), disconnect evacuator hose
(4) from the vacuum source.
10 Re-install cam and groove cap.
!
Notice
Prior to using drain, inspect for
any damage that would prevent
proper use.
When placing reservoir under vehicle,
make sure opening is directly below the
oil drain plug of the engine.
!
Notice
Prior to connecting evacuator
hose, apply a light coat of lubricating
grease to barbed fitting assembly (7).
This will make connecting the evacuator
hose easier.
Parts list
Item no. Description Part no. Quantity
1 Reservoir
4)
None 1
2 Filter screen 278407 1
3 Handle
2)
278409 1
4 Evacuator hose
3)
278410 1
5 Bolt M8 x 20
2)
278409 2
6 Mounting bracket None 1
7
Bung assembly 278442 1
*8 Hose clamp
3)
278410 1
9 Caster
1)
278408 4
10 Caster locknut 1
1
/4 in. 32 mm
1)
278408 4
1)
Included as part of kit 278408.
2)
Included as part of kit 278409.
3 )
Included as part of kit 278410.
4 )
Shown for illustration purposes and not available for order.
9 Place the filter screen (2) onto the
reservoir (1).
End of procedure
Do not attempt to drain oil from an
engine that has not cooled.
Wear proper safety equipment when
performing this procedure.
Failure to comply may result in injury
to personnel.
caution
10
1
9
7
6
2
3
5
4
8
11 Clean any waste oil from the exterior
drain surfaces.
12 Dispose of oil in accordance with local
guidelines.
End of procedure
*Indicates change.
4