Lincoln NAVIGATOR - Instrument Panel

2016 NAVIGATOR
5
1 Lighting Control
Switches on the headlamps.
Switches the headlamps off.
Switches on the parking lamps.
Autolamps*: Turns the headlamps on
and off based on available daylight.
2 Interior Lamps
Press and hold the top of the control to switch on
the interior courtesy lamps. Press the bottom of
the control to switch off the interior lamps.
3 Tilt and Telescoping Steering Column
Use the control on the side of the steering column
to adjust the position. The column automatically
moves to the full up position when you switch
the ignition off. It returns to the previous position
when you switch the ignition on. You can switch
this feature off in the information display. For more
details about your information display functions,
please see your Owner’s Manual.
4 Power-Adjustable Foot Pedals*
Located to the left of your steering column, your
power-adjustable pedal control lets you move your
brake and accelerator pedals. Press the ⊳ arrow to
move the pedals away from you or the ⊲ arrow to
move the pedals closer to you.
Note: Adjust the pedals only after you stop the
vehicle and place the transmission in park (P).
5 Cruise Control
To set the speed:
A. Press and release ON.
B. Drive to the desired speed.
C. Press SET+ and take your foot off the accelerator.
To set a higher or lower speed, press and hold
SET+ or SET– until you reach the desired speed.
Press and release either button to change a set
speed in approximately 1 mph (2 km/h) increments.
To cancel a set speed, tap the brake pedal. The
set speed saves for easy recall.
To return to a previously set speed, press RSM.
To switch off, press OFF or switch the ignition off.
6 Autowipers
To switch this feature on, move the wiper controls
to intermittent wipe. The autowiper system turns
the wipers on only when moisture is present on
the windshield. The wiper speed depends on
how much moisture the system detects and the
sensitivity setting.
Low sensitivity turns the wipers on when the
system detects a large amount of moisture on
the windshield.
High sensitivity turns the wipers on when the
rain sensor detects a small amount of moisture
on the windshield.
To switch this feature off, use your wiper
controls. To change this feature to intermittent
wipe every time you use your wipers, use the
information display.
To switch intermittent wipe back to autowipers, use
the information display.
Note: Make sure you switch this feature off before
entering a car wash.
Instrument Panel
*if equipped
4