Service Training
Section 5
Page 10
RP01 / Chapter 1
115 804 2401.1000
5.5.3 LOAD WHEEL BRAKE SHOE - FITTING
- To reassemble the brake shoes reverse the removal procedure. Ensure all springs are fitted correctly,
and that the restraining wire or band is removed from the cylinder body.
- Refit load wheel. See SECTION 4.
To ensure balanced brake performance, it is necessary to replace the shoes on both load wheel brake
assemblies. Repeat above procedure on the other load wheel brake assembly. Bed in the brakes.
5.6 LOAD WHEEL BRAKE DRUMS
If the brake drum is found to be scored during periodical maintenance, new drums must be fitted.
To Next Page
Loading...
