Line 6 Spider Jam - Output Routing and FBV Mode

Jamming with Spider Jam
4•5
Press the • Tone / Settings button three times to show the additional functions.
Turn the • Select knob to highlight Songs Set Tone.
Press • Right on the 4-way button.
Turn the • Select knob to select On or Off.
Output Routing for RCA Jacks
You can choose what signals are sent to the RCA jacks on the back of the unit:
Press the • Tone / Settings button three times to show the additional functions.
Turn the • Select knob to highlight Output Routing.
Press • Right on the 4-way button.
To have everything come out of both Spider Jam’s on-board speakers and the RCA •
jacks, turn the Select knob to select Normal.
To have the Guitar come out of Spider Jam’s 12-inch speaker and everything else •
come out of the RCA jacks, turn the Select knob to select Performance.
Setting the FBV Mode
Plugging in an optional Line 6 FBV foot controller lets you control Spider Jam with your
feet. There are two FBV Modes of operation. Normal Mode allows you to use your FBV for
User bank and channel switching, while Jam Control Mode gives you access to Transport
Controls and Song selection.
Depending on which FBV you choose to use, both modes give you access to effects on/off,
distortion boost on/off, wah/volume pedals, and tap tempo for setting delay times.
On the following page is a table of FBV functionality when using one with a Spider Jam.
*(not all functions are available from all FBVs).