Need help?Do you have a question about the Linear Access RE-2 and is the answer not in the manual?
General| Brand | Linear Access |
|---|---|
| Model | RE-2 |
| Category | Intercom System |
| Language | English |
Explains how visitors and residents interact with the RE-2 system.
Outlines methods for granting access via entry codes and transmitters.
Explains how to program the system locally or remotely via computer or telephone.
Provides guidance on mounting the RE-2 system for pedestrian and vehicular gates.
Details the recommended transformer and power wiring practices.
Illustrates wiring for gate operator installations.
Shows wiring for door or pedestrian gate installations.
Instructions for mounting the RE-2 system on a gooseneck pedestal.
Steps for mounting the RE-2 system directly to a wall or flat surface.
Procedures for recessing the RE-2 system using an accessory trim-ring.
Explains the function and importance of the Telephone Bypass Module.
Details the standard connection of the RE-2 to the residence's telephone line.
Wiring instructions for controlling a gate operator.
Wiring instructions for electric door strikes or magnetic locks.
Details the connection of the power transformer to the RE-2.
Explains the installation and use of an optional backup battery.
Instructions for proper earth grounding of the system.
Details the setup and wiring for the optional remote keypad.
Guides through the installation of a keyswitch into the RE-2 case.
Step-by-step instructions for installing the CCTV camera into the RE-2.
Instructions for setting up a dial-up network connection for programming.
Guides through connecting to the RE-2 locally via dial-up.
Guides through connecting to the RE-2 remotely via dial-up.
Explains local programming using the unit's keypad or a telephone.
Details how to program the RE-2 remotely via a telephone.
Lists programming parameters and their corresponding PPNs.
How to access the system's programming mode.
Procedure to change the system's master programming code.
How to set the system's internal clock and calendar.
Defines the number of digits for entry codes.
Procedure to add new entry codes and assign relays/time zones.
How to create entry codes with specific validity dates and usage limits.
How to add transmitters, assign them to groups, and set facility codes.
Configures which relay each transmitter button activates.
Activates or deactivates the intercom mode functionality.
Resets system settings to factory defaults, excluding codes/transmitters.
Configures relay and time zone assignments for keypads.
Defines alternative functions for Relay #2, such as alarm shunt.
How visitors use entry codes to gain access.
How visitors use wireless transmitters to gain access.
Procedures for visitors initiating a call to the resident.
Programs automatic activation times for control relays.
Configures the seven available time zones for system functions.
Procedure to temporarily suspend or reactivate individual transmitters.
To Next Page
