What to do if Linear Logic Control Systems displays nothing and has no backlight?
If your Linear Logic Control Systems unit displays nothing and the backlight is off, the issue might be a blown fuse in your vehicle. The OBDII connector typically gets power from the cigarette lighter or accessory fuse, so check that fuse first and replace it if necessary.
Why Linear Logic Control Systems never stops saying “Connecting…”?
If your Linear Logic Control Systems continuously displays “Connecting…”, there could be several reasons: * The vehicle's ECU (Engine Control Unit) might not be on. Try turning the key to the RUN position or starting the engine. * The ECU might not be responding correctly. In this case, use MORE>MORE>MODE to force specific modes. For FORD products: try PWM or CANSF. For GM products: VPW, ISO, or CANSF. For Chrysler products: ISO, VPW, or CANSF. For Volvo products: ISO, CANSF, or CANLF. For others: ISO, KWPS, KWPF, CANSF, CANLF, CANSS, or CANLS. * The vehicle might not be compatible with OBDII, OBD2, or EOBD standards. The ScanGauge requires compatibility with one of these standards.
What to do if Linear Logic Control Systems connects and then goes to sleep after 10 to 15 seconds?
If your Linear Logic Control Systems connects and then goes to sleep after a short period, consider these possibilities: 1. The engine is not running. Start the engine. 2. The ECU requires only supported PIDs (common on 1995-1999 Subaru). Set the PIDs method to SUPPORTED in the Advanced Setup Options.
General| Display Type | LCD |
|---|---|
| Dimensions | 4.8" x 1.5" x 1.0" |
| Weight | 4.2 oz |
| Number of Gauges Displayed | 4 |
| Data Logging | No |
| Diagnostic Trouble Code (DTC) Reading | Yes |
| DTC Clearing | Yes |
| Communication Protocol | OBDII |
| Compatibility | Most OBDII Compliant Vehicles (1996 and Newer) |
| Features | trip computer |
| Mounting Options | Dash Mount |
| Power Source | OBDII Port |
| Connectivity | OBD-II cable |
To Next Page
