Linear Mini-Code 3060

To Next Page

location of both the transmitter and receiver will affect

the range. If the transmitter is stowed well out of sight, it

may be necessary to remove it from its mounting and

hold near the windshield. Try different locations and

positions. If operation is still unsatisfactory, the problem

may be isolated by:

1 . Checking the door operator. If the door will not

open when the wall button is pressed, the problem

is likely to be the operator. If the door will open by

pressing the wall button, but not when the radio

control button is pressed, the problem is probably in

the radios.

2. Replacing the transmitter battery. If, after perform-

ing the above operational checks, the controls still

do not function, they should be returned to your

dealer for repair or replacement.

CAUTION:

Any changes or modifications in intentional or

unintentional radiators which are not expressly approved by

LINEAR CORPORATION could void the user’s authority to

operate this equipment. This applies to intentional and

unintentional radiators certified per part 15 of the F.C.C.

rules and regulations.

This device complies with FCC Part 15 and Industry Canada

Rules and Regulations. Operation is subject to the following

two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any

interference received, including interference that may cause

undesired operation.

LINEAR CORPORATION

2055 Corte Del Nogal

•

Carlsbad, CA 92009

INSTALLATION INSTRUCTIONS

MINI-TRANSMITTER MODEL 3060

Congratulations! You have just purchased a Mini-Code

Digital Transmitter, which we believe to be the finest

product of its kind on the market. With a little care this

transmitter should provide you with many years of

excellent service. Please take a moment to read the

following instructions and you will find that setting your

new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH AND BATTERY

COMPARTMENT

The model 3060 Mini-Transmitter case is composed of 2

halves which are held together by a small phillips head

screw. Removing this screw will allow access to both the

code setting switch and the battery compartment. (see

diagram #1)

INSTR,INSTL,MC3060,MINI-TX

LINEAR P/N: 214942 B

INK: BLACK

MATERIAL: 20 LB. MEAD BOND

SIZE: 6.250" x 4.500"

SCALE: 1-1

SIDE 1 OF 2

Need help?

Do you have a question about the Linear Mini-Code 3060 and is the answer not in the manual?

Summary

Mini-Transmitter Model 3060 Installation and Setup

Model 3060 Introduction

Welcome and overview of the Mini-Code Digital Transmitter, Model 3060.

Accessing Code Switch and Battery Compartment

Instructions for opening the transmitter case to access internal components.

Selecting a Code

Guide on setting the digital code by positioning 10 small switches on transmitter and receiver.

Transmitter Battery Replacement

Detailed steps for replacing the 12-volt alkaline battery in the transmitter.

Operational Check

Procedure for testing the transmitter's operation at a reasonable distance.

Troubleshooting and System Checks

Range and Location Factors

How transmitter/receiver location affects range and troubleshooting poor performance.

Operator and Radio Diagnosis

Steps to diagnose issues by checking the door operator and radio control functionality.

Battery Check Guidance

Advice on replacing the transmitter battery if controls do not function.

Safety and Regulatory Compliance

Modification Caution

Warning against unauthorized modifications that could void user authority.

FCC and Industry Canada Compliance

Statement on compliance with FCC Part 15 and Industry Canada Rules and Regulations.