Linear 1050 - User Manual

OPERATIONAL CHECK
To check operation, move back a reasonable distance (about 50 ft.) and press the
transmitter button. Operation should be reliable at this distance but
environment and location of both the transmitter and receiver will affect the
range. If the transmitter is stowed well out of sight, it may be necessary to
remove it from its mounting and hold near the windshield. Try different locations
and positions. If operation is still unsatisfactory, the problem may be isolated by:
1.
Checking the door operator. If the door will not open when the wall button is
pressed, the problem is likely to be the operator. If the door will open by pressing
the wall button, but not when the radio control button is pressed, the problem is
probably in the radios.
2.
Replacing the transmitter battery. If after performing the above operational
checks, the controls still do not function, they should be returned to your dealer for
repair or replacement.
CAUTION:
Any changes or modifications in intentional or unintentional
radiators which are not expressly approved by LINEAR CORPORATION could
void the user’s authority to operate this equipment. This applies to intentional
and unintentional radiators certified per part 15 of the F.C.C. rules and
regulations.
LINEAR CORPORATION
2055 Corte del Nogal • Carlsbad, CA 92009
(760) 438-7000
Copyright © 1999 Linear Corporation 216908 A
INSTALLATION INSTRUCTIONS
DIGITAL TRANSMITTER MODEL 1050
Congratulations! You have just purchased a Linear Digital Transmitter, which we
believe to be the finest product of its kind on the market. With a little care this
transmitter should provide you with many years of excellent service. Please take a
moment to read the following instructions and you will find that setting your new
transmitter will be quite an easy matter.
ACCESSING THE CODE SWITCH
On the model 1050 the side of the transmitter is removable. Squeeze the ends
of the transmitter case or twist a coin in the slot provided, then pull the side to
remove it. This will expose both the code switch and battery compartment.
INSTR,INSTL,MC1050,1CH,XMTR
LINEAR P/N: 216908 A
INK: BLACK
MATERIAL: 20 LB. MEAD BOND
SIZE: 9.000" x 3.500"
SCALE: 1-1
SIDE 1 OF 2

Summary

Operational Check

Installation Instructions

Accessing the Code Switch

Explains how to remove the transmitter side to access the code switch and battery compartment.

Selecting a Code

Guide to setting the transmitter's digital code to match the receiver by positioning 10 small switches.

Transmitter Installation

Details on self-contained transmitter operation and mounting using the included sun visor clip.

Transmitter Battery Replacement

Information on the required 9-volt battery type for the transmitter and how to replace it.

To Replace or Add a Set

Instructions for purchasing replacement units and matching digital codes with receivers.

Linear 1050 Specifications

General

Brand	Linear
Model	1050
Category	Transmitter
Language	English