Link ECU Online Manual
10
© 2024 Link Engine Management Ltd
4. Fit the Link Plug-In ECU: Remove the ECU from its packaging, unplug the USB cable from the socket
on the topboard and place ECU into the factory enclosure. Ensure the PCB is slotted into the slots
inside the case. Place the factory ECU in the packaging your Link ECU came in for its protection.
5. Refit the front cover then plug the USB cable into the socket through the hole in the back wall of the ecu
case. Secure the cable with a cable tie to prevent it being yanked.
6. If an expansion cable or CAN cable is required these are easiest to pass through the front cover beside
the header in the area shown below.
To Next Page
Loading...