Link ECU Online Manual
24
© 2024 Link Engine Management Ltd
DCCD Auto/Manual Status (0 = Manual, 1 = Auto)
SI Drive Mode (1 = Sports Sharp (S#), 2 = Intelligent (I), 3 = Sports (S))
DCCD Auto Level (Auto = 1, Auto- = 2, Auto+ = 3)
Controls Runtime directly
Steering wheel position (But not ROC)
Factory CAN Bus Information for 2015+ models (Subaru WRX 2015+ CAN Mode):
Note: These CAN Modes have not yet been widely tested in all geographic regions and on all model variants,
if you have issues with these modes please contact tech support.
This information applies to the '2015-2017 WRX JDM', '2015-2017 WRX AUDM' and '2018+ WRX AUDM'
modes.
Estimated Torque value (from Torque Control function), Clutch Switch, Gear and Inst Fuel Consumption are
used by this CAN Mode. The CE Light is controlled by CAN Aux 1.
Traction Control and DSC Disabled
DCCD Auto/Manual Status (0 = Manual, 1 = Auto)
Trac Mode (Traction Control off and DSC less aggressive)
SI Drive Mode (1 = Sports Sharp (S#), 2 = Intelligent (I), 3 = Sports (S))
DCCD bargraph (when in DCCD Manual) or DCCD Auto Level (when in
DCCD Auto - Auto = 1, Auto- = 2, Auto+ = 3)
Controls Runtime directly
Steering wheel position (But not ROC)
1.11 Known Issues
All plug-in ECUs are fully tested on a range of relevant vehicles, although there are often variations that have
not been tested. For this reason issues can arise.