Linkcom LINK 2800 DECT - Call Assignment of the Handsets; Line Assignment; Authorisations; Fax Subscribers

9
Operating Instructions
3Programming mode
Line assignment 12 1…8 2 #
When making an external call, only telephone line 2 is used to connect
the call. If this line is occupied, a busy tone will be sounded.
Factory setting: 0
3.2.3 Authorisations
Function Parameter Mob. no. Inputs
code
Authorisations 13 1…8 0 #
The handset has authorisation to make both internal and external calls.
Authorisations 13 1…8 1 #
The handset has no authorisation to make external calls. Only internal
calls can be made.
Authorisations 13 1…8 2 #
The handset has no authorisation to make internal or external calls.
Incoming calls can be accepted.
Authorisations 13 1…8 3 #
The handset has no authorisation to make internal calls.
Factory setting: 0
3.2.4 Fax subscribers
Function Parameter Mob. no. Inputs
code
Fax subscribers 14 1…8 0 #
This subscriber is a handset for voice calls.
8
3Programming mode
3.2.1 Call assignment of the handsets
Function Parameter Line no. Mob. no.
code
Call assignment 11 1…2 0…9 #
For each line, incoming calls can be assigned to a maximum of 4 call
destinations. Call destinations are the handsets 1 to 8 and hunt group call
9. With call destinations 1-8, the caller’s telephone number is displayed
via CLIP. Call destination 9 reaches all registered handsets. There is no
CLIP display, call waiting will not be signalled.
Programming example:
Calls to line 1 should be signalled on handsets 1, 3 and 6 with CLIP
display.
Calls to line 2 should be signalled on handsets 2, 3, 4 and 5 with CLIP
display. No CLIP display on other handsets.
Procedure:
1) Activate programming mode
2) Enter
111136#
3) Enter
11223459#
4) Close programming mode
Factory setting: 1, 2, 3, 9
3.2.2 Line assignment
Regardless of the setting for this programming option, the access code
can be used to seize specific lines.
Function Parameter Mob. no. Inputs
code
Line assignment 12 1…8 0 #
When making an external call, any free telephone line is used.
Line assignment 12 1…8 1 #
When making an external call, only telephone line 1 is used to connect
the call. If this line is occupied, a busy tone will be sounded.