EtherFast
®
Cable/DSL VPN Router with 4-Port 10/100 Switch
99
Instant Broadband
®
Series
98
6. Find and double-click TCP/IP in the list to the right in Figure F-2.
7. After a few seconds you will be brought back to the main Network window.
The TCP/IP Protocol should now be listed.
8. Click OK. Windows may ask for original Windows installation files.
Supply them as needed (e.g.: c:\windows\options\cabs., D:\win98,
D:\win95, D:\win9x, etc.)
9. Windows will ask you to restart the PC. Click Ye s .
The TCP/IP Installation is complete.
Figure F-3
Figure F-2
Appendix F: Installing the TCP/IP
Protocol
the TCP/IP Protocol
Follow these instructions to install the TCP/IP Protocol on one of your PCs
only after a network card has been successfully installed inside the PC. These
instructions are for Windows 95, 98, and Millennium. For TCP/IP setup under
Windows NT, 2000, or XP, please refer to your Windows documentation.
1. Click the Start button. Choose Settings, and then Control Panel.
2. Double-click the Network icon. Your Network window should pop up.
Select the Configuration tab.
3. Click the Add button.
4. Double-click Protocol.
5. Highlight Microsoft under the list of manufacturers.
Figure F-1
To Next Page
Loading...
