REGULATORY AND WARRANTY INFORMATION
FCC Statement
This device complies with Part
15
of
the FCC Rules. Operation is subject
to
the following
two
conditions:
(1)
This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This product has been tested and complies with the specifications
for
a Class B digital device, pursuant
to
Part
15
of
the FCC Rules. These
limits are designed
to
provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses,
and can radiate radio frequency energy and,
if
not
installed and used according
to
the instructions, may cause harmful interference
to
radio
communications. However, there is
no
guarantee that interference will not occur in a particular installation.
If
this equipment does cause
harmful interference
to
radio
or
television reception, which is found
by
turning the equipment
off
and on,
the
user is encouraged
to
try
to
correct the interference
by
one
or
more
of
the following measures:
• Reorient
or
relocate the receMng antenna.
• Increase the separation between the equipment and devices.
• Connect the equipment
to
an outlet other than the receiver's.
• Consult a dealer
or
an
experienced radio/TV technician for assistance.
FCC Caution: Any changes
or
modifications
not
expressly approved
by
the party responsible for compliance could void the user's authority
to
operate this equipment.
2.4 GHz operation
of
this product in the USA is firmware-limited
to
channels 1 through
11.
Selection
of
other channels is
not
possible.
Operations in the 5.15-5.25GHz band are restricted
to
indoor usage only. This device meets all the other requirements specified in Part
15E,
Section 15.407 of the FCC Rules.
FCC Radiation Exposure Statement
This equipment complies
with
FCC radiation exposure limits
set
forth
for
an uncontrolled environment. This equipment should be
installed and operated
with
minimum
distance
35
cm
between
the
radiator and
your
body.
This device and
it's
antennas(s)
must
not
be
co-located
or
operating in conjunction
with
any
other
antenna
or
transmitter
except
in
accordance
with
FCC
multi-transmitter
product
procedures.
Innovation, Science and Economic Development Canada
Statement
CAN
ICES-003(B)
/ NMB
-003(
B)
This device complies
with
ISED's license-exempt ASS standards. Operation
is
subject
to
the following
two
conditions:
(1)
This device
may
not
cause interference, and (2) this device
must
accept
any
interference, including interference
that
may cause undesired
operation
of
the
device.
For
product
available in
the
USA/Canada market,
only
channel
1-11
can
be
operated
for
2.4 GHz. Selection
of
other
channels is
not
possible.
The
device could automatically discontinue transmission in
case
of
absence
of
information
to
transmit,
or
operational failure. Note
that
this
is
not
intended
to
prohibit transmission
of
control
or
signaling information
or
the
use
of
repetitive
codes
where
required
by
the
technology.
Innovation, Science and
Economic
Development Canada Radiation Exposure Statement
This equipment complies
with
ISED radiation exposure limits
set
forth
for
an uncontrolled environment. This equipment should be
installed and
operated
with
minimum
distance
35
cm
between
the
radiator &
your
body
.
This device and
its
antennas(s) must
not
be
co-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter
except
in
accordance
with
ISED multi-transmitter
product
procedures.
Restrictions
in
the
5 GHz Band
The
device
for
the
band 5150-5250
MHz
is
only
for
indoor
usage
to
reduce
potential
for
harmful interference
to
co-channel
mobile
satellite systems.
This device has been designed
to
operate
with
an antenna having a maximum gain
of
4.09
dBi
and 3.81 dBi
at
2.4
GHz
and 5 GHz
To Next Page
Loading...
