E For the Connection Type
setting, six connection types
are offered through the
drop-down menu. Each Setup
screen and available features
will vary depending on which
connection type you select.
Internet Connection Type
Automatic Configuration -
DHCP: If you are connecting
through DHCP or a dynamic IP
address from your ISP, keep
this default setting.
Static IP: If your ISP assigns
you a static IP address, select
Static IP from the drop-down
menu. Complete the Internet
IP Address, Subnet Mask,
Default Gateway, and DNS
fields. You need to enter at
least one DNS address.
PPPoE: If you are connecting
through PPPoE, select PPPoE
from the drop-down menu.
Complete the User Name and
Password fields.
PPTP: PPTP is a service used in
Europe only. If you are using a
PPTP connection, check with
your ISP for the necessary
setup information.
Heartbeat Signal. Heartbeat
Signal is used primarily in
Australia. Check with your ISP
for the necessary setup
information.
L2TP. L2TP is used mostly in
Europe. Check with your ISP
for the necessary setup
information.
F When you are finished
entering your Internet
connection settings, click the
Save Settings button to save
your changes.
G Restart or power on your PCs
so they can obtain the router's
new settings.
H Test the setup by opening
your web browser from any
computer and entering
http://www.linksys.com/
registration.
Congratulations! The installation
of the Router is complete.
These instructions will show you
how to configure the Router. You
only need to configure the Router
once using any computer you have
set up.
A Open your web browser. Enter
http://192.168.1.1 in its
Address field. Press the Enter
key.
B A password request screen
will appear. Enter the default
user name and password,
admin, in lowercase letters in
the User Name and Password
fields. (For added security, you
should later set a new
password, using the
Administration tab’s
Management screen of the
web-based utility). Then click
the OK button.
C The web-based utility will
appear with the Setup tab and
IP Mode selected. Click on the
WAN option under the Setup
tab.
D If requested by your ISP
(usually cable ISPs), complete
the Host Name and Domain
Name fields, and the MTU and
MTU Size fields. Otherwise,
leave the defaults.
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2006
Cisco Systems, Inc. All rights reserved.
RVS4000-QI-60524NC RR
For additional information or troubleshooting help,
refer to the User Guide on the CD-ROM. You can
also call or e-mail for further support.
24-hour Technical Support
800-326-7114
(toll-free from US or Canada)
E-mail Support
support@linksys.com
Website
http://www.linksys.com or
http://support.linksys.com
RMA (Return Merchandise Authorization)
http://www.linksys.com/support
FTP Site
ftp://ftp.linksys.com
Sales Information
800-546-5797 (800-LINKSYS)
2
Configure the Router
A
C
B
Automatic - DHCP
Static IP
PPPoE
PPTP
NOTE: For more advanced
settings and security options,
refer to the User Guide on the
RVS4000 CD-ROM.
Heartbeat Signal
L2TP
To Previous Page
Loading...
Need help?
General
