tatement
DECLARATION
OF
CONFORMITY WITH FCC RULES FOR ELECTROMAG-
NETIC COMPATIBILITY
We,
LINKSYS
of
121
Theory, Irvine, CA
92617,
declare under our sole responsi-
bility
that
the Class 8 Gigabit Switch products
to
which this declaration relates,
comply
with
Part
15
of
the FCC Rules. Operation is subject
to
the following
two
conditions:
(1)
This device may
not
cause harmful interference, and
(2)
this
device must accept any interference received, including interference
that
may
cause undesired operation.
This product has been tested and complies with the specifications
for
a Class
8 digital device, pursuant
to
Part
15
of
the
FCC
Rules. This equipment gener-
ates, uses, and can radiate radio frequency energy and,
if
not installed and
used according
to
the instructions, may cause harmful interference
to
radio
communications. However, there is no guarantee
that
interference will
not
occur
in a particular installation.
If
this equipment does cause harmful interference
to
radio or television reception, which is found by turning the equipment
off
and
on,
the user is encouraged
to
try
to
correct the interference by one or more
of
the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment
to
an outlet other than the receiver's
• Consult a dealer
or
an experienced radio/TV technician
for
assistance
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority
to
operate this equipment.
Innovation Science and Economic Development Canada
Statement
This digital apparatus complies with CAN ICES-3(8).
Operation is subject
to
the following
two
conditions:
1.
This device may
not
cause interference and
2. This device must accept any interference, including interference
that
may
cause undesired operation
of
the device.
Avis d'Avis d'lnnovation, Sciences
et
Developpement economique Canada
Cet appareil numerique
est
conforme aux normes NMB-3(8) du Canada.
Le
fonctionnement est soumis aux conditions suivantes :
1.Ce peripherique
ne
doit
pas causer d'interferences;
2.Ce peripherique
doit
accepter toutes les interferences
rec;ues,
y compris
celles qui risquent d'entra,ner
un
fonctionnement indesirable.
■
To Next Page
Loading...
Need help?
General
