Name: Linksys Velop WHW0302
Brand: Linksys
Rating: 5 (1 reviews)

To Next Page

To Previous Page

How to restore factory defaults

You should never need to factory reset your Velop------ a very disruptive process. A factory reset

restores your Velop system to the state it was when you took it out of its box, requiring you to go

through the setup process again. All settings you have customized in setup and since - -- things such as

Wi-Fi name, passwords, security type - -- will be erased. All wireless devices will disconnect from your

Wi-Fi.

To reset Velop:

•

With your node connected to power and turned on, press and hold the Reset button on the

bottom. The light on top of the node will turn red and fade in pulses. Do not release the button

until the light goes out and then turns bright red.

Note—If you have more than one node in your Velop system, you might need to reset them all to

factory default settings. You can do that by resetting the main node; all other nodes will reset

automatically.

Questions and Answers:

Need help?

Do you have a question about the Linksys Velop WHW0302 and is the answer not in the manual?

Linksys Velop WHW0302 Specifications

General