EasyManuals Logo

Linksys Velop WHW0302 User Manual

Linksys Velop WHW0302
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
Bottom view
1.
Reset button------Press and hold until the light on top of the node turns red, fades and flashes
bright red again to reset the node to its factory defaults.
2.
Ethernet ports------ Connect Ethernet cables to these Gigabit Ethernet (10/100/1000) ports
and to other wired devices on your network. If you have more than one node in your Velop
system, use one of these ports to connect to your modem or modem router.
Note—For best performance, use a CAT5e or higher rated cable on the Ethernet port.
3.
Power switch------Press | (on) to power on the node.
4.
Power port------Connect the included AC power adapter to this port.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys Velop WHW0302 and is the answer not in the manual?

Linksys Velop WHW0302 Specifications

General IconGeneral
BrandLinksys
ModelVelop WHW0302
CategoryNetwork Router
LanguageEnglish

Related product manuals