Read the License Agreement
and click Next to continue the
installation.
Power off your PC. After installing
the Adapter, as shown below,
and restarting your PC, the Setup
Wizard will continue.
Open your PC case and locate
an available PCI slot on the
motherboard. Check with your
computer manufacturer for
instructions.
Slide the Adapter into the PCI slot.
Make sure that all of its pins are
touching the slot’s contacts. You
may have to apply a bit of pressure
to slide the Adapter all the way in.
After the Adapter is firmly in place,
secure its fastening tab to your PC’s
chassis with a mounting screw.
Then close your PC case.
Now you will connect the antenna
stand’s cables to the PCI card of
the Adapter. Plug the cable with
the blue connector into the blue
CENTER ANT port. Then attach the
remaining cables to the other ANT
ports.
Power on your desktop PC.
C.
D.
To Next Page
Loading...
