Before starting the physical installation,
note the PrintServer’s Default Name,
which is located on the bottom of the
PrintServer.
A Plug one end of the Ethernet net-
work cable into the PrintServer’s
LAN port.
B Connect the other end to your
networked hub, switch, or router.
C Use the USB cable to connect
your USB printer to the PrintServer’s
USB port.
D Use the parallel printer cable (not
included) to connect your parallel
printer to the PrintServer’s parallel
port.
E Power on your printer.
F Plug the power adapter’s cord
into the PrintServer’s Power port.
G Plug the power adapter into an
electrical outlet.
Connect the PrintServer
A
C
D
F
To Next Page
Loading...
