B
Configure the PrintServer
A Insert the Setup CD-ROM into the
computer’s CD-ROM drive. The
Setup Wizard should run automati-
cally. If it does not, click Start
and choose Run. In the box
that appears, enter
D:\setupWizard.exe (if “D” is the
letter of your CD-ROM drive).
B On the Welcome screen, click
Setup Wizard.
C The Setup Wizard will search for
the PrintServer. After it has been
found, the screen in Figure C will
appear. If this is the first time you
have run the Setup Wizard, make
sure that List only new (unconfig-
ured) Print Servers is selected and
your PrintServer is listed by its
default server name. If you have
previously configured the Print-
Server, select List all compatible
Print Servers. Click Next.
D On the Password screen, enter the
default password, admin. Click
Enter.
E On the Basic Settings screen, you
may change the Device Name
and Domain Name settings if you
want. Then click Next.
F The IP Settings screen will appear.
If your network uses a router that
automatically assigns IP
addresses, select Automatically
obtain an IP address (DHCP) and
click Next. If you need to assign
the PrintServer a static IP address,
select Set IP configuration manu-
ally, and enter the IP Address,
C
D
E
To Next Page
Loading...
