4
Subnet Mask, and Gateway in the
fields provided. Then click Next.
G On the Set PrintServer’s Password
screen, enter the PrintServer’s
default password, admin, in the
Current Password field. Enter a
new password in the New Pass-
word field, and enter it again in
the Verify Password field. Click
Next.
H On the Wireless Settings screen,
enter your wireless network’s SSID
or name.
NOTE: It is important that you
read and observe the
domain setup instructions
below. Users must select
the correct domain during
the setup and obtain any
permit or authorization to
operate this product as
required by the governing
laws of that country. Link-
sys disclaims any liability
whatsoever as permitted
by law if the following
domain setup is not
observed. This device is
not meant for outdoor
use.
Select the continent you’re
located in for the domain (Africa,
Asia, Australia, Europe, or South
America) from the drop-down
menu. If you’re located in France,
Israel, Japan, or Mexico, select
your country from the list.
G
F
H
To Next Page
Loading...
