12
Chapter 4: Connecting the Wireless-G Broadband Router with 2 Phone Ports
Placement Options
Wireless-G Broadband Router with 2 Phone Ports
Placement Options
There are three ways to place the Router. The first way is to place it horizontally on a surface, so it sits on its four rubber feet.
Another option is to install the stand onto the bottom of the Router, so the Router is in an upright position. Make sure to place
the Router’s bottom edge of the Cisco logo in between the stand’s prongs until tight. The third way is to mount it on a wall.This
option uses the Router’s four wall-mount slots on its bottom panel. The distance between two adjacent slots is 60 mm (2.36
inches).
To use the wall-mount option, follow these instructions:
1. Make sure you have four screws that are size #4—this indicates a diameter measurement of 2.845 mm (0.112 inches).
2. Determine where you want to mount the Router.
3. Drill four holes into the wall. Make sure adjacent holes are 60 mm (2.36 inches) apart.
4. Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.
5. Maneuver the Router so the wall-mount slots line up with the four screws.
6. Place the wall-mount slots over the screws and slide the Router down until the screws fit snugly into the wall-mount
slots.
Proceed to
“Chapter 5: Configuring the Wireless-G Broadband Router with 2 Phone Ports” for directions
on how to configure the Router.
60 mm
(2.36 inches)
Figure 4-10: Measurement between Wall-
Mount Slots
To Next Page
Loading...
