Linksys WUSB6100M User Manual

Installation
1. Insert the USB adapter into an open USB port on your computer.
2. Watch your monitor/screen as the device automatically installs.
3. Connect to your Wi-Fi network using your computer’s network manager.
Note—If the adapter did not install automatically, use the provided CD or download and run
the driver installation file available at linksys.com/support/wusb6100m.
Connect with Network Manager
Choose your operating system.
•
Windows 10
•
Windows 8.1
•
Windows 7
Windows 10
1. Click the Wi-Fi network icon . The Network menu opens from the right side of the
screen, showing you available Wi-Fi networks and your current connection status.
2. Choose a network. If prompted, enter any additional required network information
(such as password).
Windows 8.1
1. Click Settings in the lower-right corner of the screen.
2. Click the Wi-Fi network icon . The Network menu opens from the right side of the
screen, showing you available Wi-Fi networks and your current connection status.
3. Choose a network. If prompted, enter any additional required network information
(such as password).
Windows 7
1. Click the Wireless Network Configuration utility icon in the lower-right corner of the
screen. A list of available Wi-Fi networks will appear.
2. Choose a network and click Connect.
3. If prompted to enter a network security key, type your password (security key) into the
network security key field. Click OK.
4

Linksys WUSB6100M Specifications

General

Interface	USB 2.0
Frequency Bands	2.4 GHz, 5 GHz
Antenna	Internal Antenna
Security	WEP, WPA, WPA2
Wireless Standards	IEEE 802.11n
Wireless Speed	300 Mbps
Operating Systems Supported	Windows 7, Windows 10