3
Connection of the loudspeakers to the amplifier should be made with a good quality cable. Linn K20
loudspeaker cable is ideal, the leads should be terminated with the connectors supplied to ensure
optimum performance. The use of other connectors will degrade the sound quality of your system.
The cable is marked with the Linn symbol to indicate directionality. The bare wires shown should be
connected to the amplifier and the end marked with the circular logo should he connected to the
loudspeakers.
< LOUDSPEAKERS AMPLIFIER >
Take care to ensure that the wiring is correct. The red socket is positive and the black is negative. The
positive wire (red connector) is identified by a rib along the side of the cable.
HELIX speakers are designed to perform best when placed close to a wall. Ideally the rear of the
loudspeaker should be between 4" and 12" (10 and 30cm) from the wall and at least 18" (45cm) from any
corner.
HELIX can also benefit from being angled inward slightly by 5 to 10 degrees.
These are general guidelines and a little experimentation with positioning will optimise results for a
particular room, your dealer will be pleased to do this when he installs your equipment.
To Next Page
Loading...
