Linn Lingo - CONNECTION AND OPERATION; Connecting the LINGO to LP12; LINGO Power Supply Operation

The deck should be re-placed in its original packing. The outer platter must be
removed and placed in the bottom packing tray, the inner platter removed and placed
in the top tray. Remove the counterweight before removing the arm and cartridge.
NOTE
Under no circumstances should the deck be shipped with the arm fitted
to the turntable.
The red bearing cap should be re-fitted to prevent oil spillage from the
bearing housing.
See diagram for packing assembly.
IMPOR
TANT When re-packing the turntable remove the two bottom cover screws
which are located between the turntable feet. If these screws are left in position
during shipping, they will damage the rim of the platter.
To connec t the LINGO to the LP12, hold the 8 pin din plug by the black plastic
portion and push into the 8 pin din socket on the LINGO back panel, until the
aluminium lock ring snaps into lock.
To disconnect, first make sure the mains are switched off, then gripping the 8 pin din
plug by the aluminium lock ring, pull back to remove the plug.
The switch on the LP12 provides a trigger to the electronics to start, stop or change the
speed of the motor.
.
It does not break any mains connection. The power switch on
the LINGO power supply isolates mains. However, to prevent electric shock, never
remove the bottom cover from the turntable with the LINGO connected, or the case
from the LINGO power supply while it is connected to the mains
CONNECTION
OPERATION
2
lingo manual 2007+ 3/9/07 3:17 PM Page 6