Need help?Do you have a question about the Linn LK 100 and is the answer not in the manual?
Set voltage selector to match country of use; use earthed mains lead; ensure appliance is earthed.
Connect mains lead colours (Green/Yellow, Blue, Brown) correctly to plug terminals.
Switch off pre-amplifier and power amplifier before connecting or disconnecting plugs.
LINE INPUT and OUTPUT sockets enable signal chaining for multi-amplifier setups.
Route signal to first LK100's LINE INPUT, chain to subsequent units via LINE OUTPUT to LINE INPUT.
Remove speaker terminal links when passively bi-amping to avoid shorting outputs and damaging amplifier.
Features over-current and over-temperature sensors to protect against short circuits and overheating.
Switch off and wait approx. 40 seconds for the amplifier to re-set and resume working.
Drives two pairs of 8 ohm or one pair of 4 ohm loudspeakers; two pairs of 4 ohm may trip protection.
The LK100 is designed for long life; any servicing should be carried out by an authorised dealer.
Unauthorized servicing or dismantling invalidates manufacturer's warranty; refer all enquiries to authorised dealers.
To Next Page
General
