Chapter 2: Get started
FA69315–5 English 27 Linx 5900 & 7900 Quick Start Guide
2.5 Stop and turn off the printer
This section tells you how to safely stop the printer and turn off the
electrical supply.
Use the red [stop] key to stop printing and turn off the printer. For example,
if you do not need the printer until the next day. Do not use the red [stop]
key to stop printing for a short time, because this key stops the jet.
CAUTION: Always use the correct procedure (described below) to
shut down and turn off the printer. Do NOT use the mains power
supply switch to stop the printer, except in an emergency.
Use the correct procedure to make sure that any changes are saved
and the printhead is cleaned. If you use the mains power supply switch
to stop the printer, you can lose any changes and cause printhead
problems. Thorough cleaning of the printhead will be necessary.
2.5.1 Power-Down configuration
The printer can turn off automatically when the jet is stopped, or if the
printer is idle for some time. The supervisor or maintenance engineer can
configure the power-down options, and can disable the function if
necessary. The default setting is that power-down is enabled.
2.5.2 To turn off
To stop print and turn off the printer, do the following:
If the jet is stopped (idle):
Press the red [stop] key. The printer displays a prompt message:
Figure 2-19. Power-Down prompt screen
Press the Yes key to turn off the printer.
To Next Page
Loading...
