Lionelo Bella - Remote Control Operation; Power and Battery Management; Power Supply Usage

‑ 12 ‑EN
2. Moon detecon indicator
The indicator lights up when the child moon detecon funcon is enabled.
3. Power indicator
The indicator lights up when the device is on.
4. On/o switch
5. Selecon of rocking speed
Select one of the rocking speeds (1-5).
6. Remote control receiver
7. Baby moon detecon on/o switch
8. Change of the rocking mode
9. Melody selecon
10. Automac mode
The mode changes about every 16 seconds.
11. – 15. Five rocking modes
16. Night mode
Acvang this mode will cause the device to slow down the rocking unl it
stops completely.
Remote control (g. D)
1. Baery compartment lid
2. On/o switch
3. Play or stop the melody
4. Next melody
5. Previous melody
6. Increasing the volume
7. Reducing the volume
8. Selecon of the rocking speed
9. Change of the rocking mode
10. Baby moon detecon on/o switch
11. Baery compartment
Power supply
Connect the USB cable to the power supply, and then plug the power supply
into a power outlet. Place the other end of the cable in the DC port located in
the base of the rocker (6, g. A).