Lionelo Koen - Product Outline; Safety Belts

 EN

see g. 1
 Seat
 Tray
 Upper front leg (with
a footrest screw hole)
 Footrest
 Lower leg
 Safety belt
 Upper rear leg (without
a footrest screw hole)
 Adjustment foot
 Footrest mounng screw
 Mounng connectors

Before you start assembling, make sure you have all parts and that they are not
damaged.
 Screw two upper front legs (with a screw hole) and two rear legs (without
holes) to the seat. Tighten front legs up so that footrest screw holes are
posioned to the front (g. 2).
 Put the footrest on the front legs, previously screwed into the seat (above
the screw holes) (g. 3).
 Screw lower legs to upper legs. You can adjust the level with feet.
 Insert the tray into the seat unl you can hear a disncve click (g. 4).
 To have a lower chair variant (g. 5):
 unscrew lower legs,
 unscrew adjustment feet from lower legs,
 screw feet to upper legs on.



 To x belts, carry belts through relevant holes in the seat (g. 6).
 Pull the belt and make sure it has been properly locked in the seat.
 To dismount the belt, straighten the belt lock and gently push through the
hole in the seat (g. 7).