Lionelo Koen - Cleaning and Maintenance

EN

To make sure your child is safe and does not fall from the chair, fasten safety
belts, as showed in the picture below (g. 8).
 Put upper belt buckles on the side belt buckle.
 Insert buckles into the fastening.
 Make sure the belt has been fastened properly.
 To undo the belt, press the buon in the fastening.

You can choose 2 heights of the footrest.
 Remove the footrest from the product. Next loosen screws which connect
plasc connectors (J) to the wooden footrest. See g. 9.
 To install in a higher posion, slide plasc connectors to the center and
ghten the screws up. To install in a lower posion, slide plasc connectors
to the outside and ghten the screws up. Aach the footrest on the product.
 Screw in the screws. Slide the footrest over the screws that support it (g. 3a).

Keep the chair clean and take care of it to prevent your child against accidental
injuries.
 To clean the product, use a wet cloth. You can use a so detergent.
 Regularly check if all elements have been ghtened up properly and there
are no loose parts.
 Regularly check operaon of the safety belt mechanism.
 If you do not use the chair, keep it in a clean and venlated place. Avoid
direct sunlight.
 Never use strong detergents, polishing materials, bleaches and alcohol-rich
products.
The pictures are for reference only. The real design of the products
may dier from the pictures presented.