Lionelo Natt - Harness Adjustment; Footrest Adjustment; Seat Adjustment

‑ 10 ‑EN
Harness
1. Insert the fastener components into the main buckle (g. 11). A correct
connecon will signal a click.
2.
Adjust the length of the harness to the child’s body using the buckles located
on the straps (g. 12).
3. To unbuckle the harness, press the buon located in the buckle (g. 13).
Harness adjustment
To adjust the harness, remove the buckle through the hole located in the seat
and put it in the desired place.
Make sure that the buckles are in the correct, stable posion aer reposioning.
Installaon and removal of the safety bar
1. Insert the safety bar into the connectors on the stroller frame (g. 7). Correct
installaon will signal a click.
2.
To remove the safety bar, press the release buons located on the inside
of the frame. Push the buons independently on both sides of the stroller,
then pull out the safety bar.
Footrest adjustment
1. To lower the footrest, press both adjustment buons (g. 8) and set the
footrest to the desired posion.
2. To raise the footrest, li it and move it to the desired posion.
A click will signal that the footrest is locked in the selected posion.
Seat adjustment
Note! Do not adjust the seat when there is a child in the stroller.
To change the posion of the seat, use the buckle located on the adjustment
strap at the back of the backrest (g. 9).
1. Slide the buckle down to the end of the adjustment strap to adjust the seat
to the reclining posion.
2. Slide the buckle upward to adjust the seat to a sing posion.
Parking device
Press to lock the wheels and stop the stroller. Li to unlock (g. 10).