Lionelo sander - TOP TETHER Strap Attachment; Connecting TOP TETHER to Fixing Points

‑ 12 ‑EN
in a face-forward or rear-forward posion). To do so, pull and hold the interlock
buon of ISOFIX handles and posion them in a proper direcon by sliding the
enre handle horizontally outwards. Lock ISOFIX connector in the handle (g.
5.1-5.3). Pull out guides by pressing a grey ISOFIX adjustment buon. Repeat
acons on the other side (g. 5.4-5.5).
If your vehicle is not equipped with ISOFIX anchor guides, use two plasc guides
supplied with the safety seat (g. 5.6). Push the guide in the gap between the
backrest and a seat, and hook its p to ISOFIX anchor (g. 5.7).
If you can hear two clicks, the safety seat has been mounted properly and ISOFIX
markers will turn from red into green.
The child restraint in a rear-facing posion may be secured with three-point
safety belts (g. 6).
WARNING! If the indicators on the ISOFIX connector are red, it means that the
seat has been badly aached. Mount the safety seat again. Pull the seat rmly
to make sure that it is properly aached (g. 7)
TOP TETHER upper strap aachment
The top strap adjustment can increase the xing strength, however it’s not suitable
in case of some vehicles (including those equipped with ISOFIX connectors). The
posion of the xing points may vary depending on a given vehicle.
Connecng the top strap to xing points (g. 8)
A. Aaching to the oor of the trunk behind the rear seats.
B. Aaching to the oor of the trunk behind the rear seats.
C.
Fixing just under the seat of the vehicle, you have to put the seat to nd the hook.
D. Aaching to the rear vehicle seats.
Make sure the connectors of ISOFIX xing system have been installed properly
Press adjustment buon on the upper hook, draw a sucient amount of TOP
TETHER strap so that its length is sucient to hook on the car xing point.
Make sure the belt has not been twisted and is well-posioned in relaon to the handle in the car.