Lionelo sander - Installation Instructions by Group and Method; Group 0+ (0-13 kg) with ISOFIX; Group 0+ (0-13 kg) with Safety Belts; Group I (9-18 kg) with ISOFIX

‑ 14 ‑EN
posioned in the ready safety seat. Fasten 5-point safety belts. Press belt adjustment
buon (in front the safety seat) with one hand, use another hand to pull adjustment strap to
ghten arm belts. Make sure the belt pads remain on the child’s arms. You can disassemble
the belts if your child weighs more than 15 kg or its height exceeds 1 meter (g. 17).
Installaon for Group 0+ (0-13kg) with ISOFIX
Posion the backrest at maximum lng (4-th posion of adjustment). In this
posion the backrest must be tled as much as possible. The safety seat must be
in a rear-facing posion. To do so, slide ISOFIX guides to the front of the safety
seat (see instrucons above, g. 18). Mount the safety seat in accordance with
ISOFIX assembly instrucons described above. Mount TOP TETHER upper strap
as instructed above. Press a red buon on the clamp of 5-point safety belts to
unlock belts. Spread safety belts of the safety seat to sides, next place your child
properly. Combine two metal clamps. Insert two parts of the metal clamp in the
handle. If you can hear a click, the belt is locked. Make sure the belt has been
locked properly. Push belt adjustment to ghten harness of the safety belts. If
belts t a child ght, the protecon is fully guaranteed (g. 18).
See g. 19-The posion of the safety
Installaon for Group 0+ (0-13kg) with safety belts
Grip the red lever at the front of the child car seat and pull the seat into
its fully reclined posion (g. 20.1). The seat must be fully reclined when
facing rearwards. Plaing the child car seat on passenger seat. Placethe child
car seat on a passenger seat facing rearward (g. 20.2). Roung diagonal
and lap belts correctly. Put the lap belt under innercushion (fig. 20.3).
In the meanwhile, bring the diagonal belt through the belt guide round the back
of the seat (g. 20.4). Tightening the child car seat. Check and make sure there
is no twist of the belt. Insert the metal tongue of caberbelt into the carseat
buckle unl you hear a clear “click” (g. 20.5). Tighten the seatbelt by pulling in
the direcon of the seatbelt reel (g. 20.6). Pull the lap and diagonal seat belt
ghtly and aach the belt lock to the diagonal secon of the seatbelt. Ensure it’s
aached as close as possible to the seatbelt buckle without touching it (g. 20.7).
Installaon for Group I (9-18kg) with ISOFIX
The safety seat must be in forward-facing posion.