Lionelo sander - Group I (9-18 kg) with Safety Belts; Group II;III (15-36 kg) with ISOFIX

‑ 15 ‑ EN
To do so, slide ISOFIX guides to the back of the safety seat. The safety
seat must be in sitting position (fig. 21.1). Mount the safety seat
in accordance with ISOFIX assembly instructions described above.
Make sure the safety seat is ts ght the backrest of the car seat. Pull the safety belt.
Pull through the safety belt in the back of the backrest with marked guides (between
a frame and car seat cover), pull out a belt from the other side of the safety seat and
unlock it by inserng in the car belt clamp. Tighten the belt and see if the safety
seat has been mounted properly. If it is sll slackened, ghten the belt again (g.
22.1-22.3). Spread safety belts of the safety seat, next place the child in the safety
seat well. Combine two parts of the metal clamp. Insert two parts of the metal
clamp in the handle. If you can hear a click, the belt is locked. Make sure the belt
has been locked properly. Pull belt adjustment to ghten hardness of the safety belt.
If belts t your child ght, it is fully protected (g. 22.4-22.8).
Installaon for Group I (9-18kg) with safety belts
The safety seat must be in a forward-facing posion. Posion the safety seat on the
car seat so that its backrest ts the backrest of the seat ght. Pull the safety belt.
Pull through the safety belt in the back of the backrest with marked guides
(between a frame and the safety seat cover), pull out a belt on the other side of
the safety seat and lock it by inserng in the car belt clamp. Tighten the belt and
check if it is well mounted. If it is sll slackened, ghten the belt again (g. 21.1-
21.3). Spread safety belts of the safety seat, next posion your child in the safety
seat well. Combine two parts of the metal clamp. Insert two parts of the metal
clamp in the handle. If you can hear a click, the belt is locked. Make sure the belt
has been locked properly. Pull belt adjustment to ghten harness of the safety
belts. If belts t your child ght, it is fully protected (g. 22.4-22.8).
See g. 23- The safety seat can be in posion 1, 2 or 3
Installaon for Group II and III (15-36kg) with ISOFIX
Remove the safety belts of the safety seat (see instrucons below). In this posion
the safety seat must be in forward-facing posion, posion ISOFIX handles properly
(in accordance with the descripon above). Mount the safety seat in accordance with
ISOFIX assembly instrucons described above. Set a relevant height of the headrest
(see instrucons above). Carry the car belt in front of the safety seat. Fasten the
belt clamp in the buckle and posion the hip belt in lower guides. Pull through