Lionelo sander - Group II;III (15-36 kg) with Safety Belts; Disassembly and Maintenance; Disassembly of 5-Point Belts; Removing the Cover

‑ 16 ‑EN
upper part of the harness belt through the guide in the headrest from the car belt
retractor side. Make sure the belt is in the belt guide and is not twisted. Tighten
the belt by Pulling its breast part towards the belt retractor. Make sure the hip
belt goes through the center of the child’s collarbone. If the belt is too close to
the child’s neck, adapt it to the headrest again (g. 24).
Installaon for Group II and III (15-36kg) with safety belts
Remove safety belts of the safety seat (see instrucons below). In this posion
the safety seat must be in forward-facing posion. Place the safety seat on the
car seat so that its backrest ts the backrest of the car seat ght. Place the child
in the safety seat. Set a relevant height of the headrest (see instrucons above).
Carry the car belt in front of the safety seat. Fasten the belt clamp in the buckle
and posion the hip belt in the lower guides. Pull through the upper part of
the harness belt through the guides in the headrest from the car belt retractor
side. Make sure the belt is in the belt guide and is not twisted. Fasten the belt
by pulling its breast part towards the belt retractor. Make sure the harness belt
goes through the center of the child’s collarbone. If the belt is too close to the
child’s neck, adapt the headrest again (g. 24).
See g. 25-The safety seat must be in posion 1
Disassembly of 5-point safety belts
Slacken belts o and open the harness clamp. Pull out the buckle from the safety
belts (in the back of the safety seat). Pull out arm belts from the safety seat. Pull out
the crotch belt from the metal buckle under the base of the safety seat, and pull it by
taking out the enre crotch belt along with the buckle from the hole (g. 26). To mount
ve-point safety belts in the safety seat, follow the same acons in reversed order.
Removing a cover
Remove 5-point safety belts in accordance with the instrucons above. Undo
an addional headrest cushion. To remove a cover, start from the boom of the
safety seat and end up with its headrest (g. 27).
Cleaning
Use natural detergents and warm water (below 30°C). Do not wash in the washing
machine. Do not swirl and squeeze. Note: Extensive scrubbing may damage the