Lionelo Timon - Page 8

‑ 8 ‑EN
pulling the plasc level downwards (g. 11).
NOTE! When using the baby’s bed, remember to lock all wheels.
BABY’S BED HEIGHT ADJUSTMENT
The baby’s bed height can be adjusted at 6 levels. The product’s height can be
adjusted independently from each side, thanks to which it is possible to set an
inclinaon. The height changing buons are located on both sides of the product,
just under the top frame of the bed. To change the height, press the buon on one
side of the bed, then li or lower the bed as desired. Do the same on the other side.
WARNING: The maximum permissible inclinaon of the baby’s bed is a dierence of
2 levels. The child’s head must always be higher than other parts of the body (g. 12).
NOTE! Before you change the height of the maress, take the child out of the bed.
FUNCTION OF THE BEDSIDE SLEEPER
Timon baby’s bed can be used as an bedside sleeper (aached to parents’ bed). Before
you use the product for this purposes, make sure the baby’s bed has been placed
properly, and linking belts have been aached and tensed up as requested. The
product must be aached to parents’ bed in a way that excludes any gaps between
the product and the maress. When using, make sure the bedding, quilt, etc. do not
take space in the bed.
NOTE! It is allowed to use the product solely by the beds and/or maresses
with straight sides. The use of the product by the round or water beds and/or
maresses is forbidden.
To make use of the bedside sleeper, prepare the product for such use properly.
To do so, follow the points below:
1. Unzip on both sides of the opening side (g. 13)
2. Release the protecon by pressing the buons on the frame and slide the
metal frame tube out of the clips.
3. Push the baby’s bed closer to the parents’ bed.
4. Adjust the height of the cot (g. 14).
NOTE! When using the baby’s bed as an bedside sleeper, the height must be the
same on both sides.
5. Use the belts to aach the baby’s bed to parents’ bed. Fasten the belt from
the internal side of the le and right frame, and then wrap around the bed’s
frame and fasten it.