Lionelo Timon - How to Disassemble; Cleaning and Maintenance

‑ 9 ‑ EN
6. Tighten the belts and make sure the baby’s belt has been aached to parents’
bed properly.
TRAP RISK
In order to avoid trap risk, the baby’s bed must be secured properly and aached
to parents’ bed as recommended. The product must be aached to parents’ bed
in a way that excludes any gaps between the product and the maress.
If this is impossible, do not use the product as a bedside sleeper.
WARNING! Before each use, check that there is no gap between parents’ maress
and the side wall of the baby’s bed.
FALL RISK
The baby’s bed is designed for children whose weight does not exceed 9 kg. Remember!
Always li the side of the baby’s bed when it is not aached to the parents’ bed.
NOTE! If the child can sit, kneel or pull itself, it should not use the baby’s bed anymore.
HOW TO DISASSEMBLE
1. Take the maress out.
2. Set the height of the baby’s bed to level II.
3. Press both buons under the top frame of the baby’s bed at a me (on both
sides) (g. 15).
4. Upper components of the bed’s frame will fold (g. 16).
5. Fold in the boom of the bed.
6. Fold up the basket by liing it up.
7. Wrap the maress around the internal part of the baby’s bed (g. 17).
8.
Press the buon by the base to fold lower components of the bed’s frame (g. 18).
9. Do the same on the other side.
CLEANING AND MAINTENANCE
The product should be washed by hand using a mild detergent. Do not iron, do
not tumble dry. Maress: machine wash at 60°C.
The product has been tested and meets all the requirements of the following standards: EN
1130:2019+AC:2020, EN 16890:2017+A1:2021
The pictures in this manual are for illustrave purposes only. Therefore, they may dier from the actual
product.