Lippert Components Solera Slide Topper Owner's Manual

Rev: 12.09.20 Page 3 CCD-0003956
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
Operation
Operation of the Solera® Slide Topper runs in parallel with the operation of the slide-out onto which it is
mounted. Consult the Owner's Manual for the respective slide-out for general operation.
Note: Ensure the fabric rolls and unrolls evenly from the roll tube. Failure to ensure this may result in
damage to the Slide Topper or the slide-out in the event of misalignment.
Maintenance
Fabric Care
If the awning is retracted while wet, extend the awning and let it dry as soon as conditions allow before
again retracting. This will help prevent the formation of mildew and add to the life of the awning.
Note: Mildew does not form on the fabric itself, but on the accumulated dust, dirt and grime.Periodically
clean vinyl or woven acrylic fabric using a mixture of 1/4 cup of dish soap and five gallons of warm
water.
1. Liberally apply the mixture on the top of the fabric and retract the awning for five minutes.
2. Apply the mixture to the bottom of the fabric as well.
3. Extend the awning and hose off with fresh water.
4. Repeat if necessary.
5. Allow to dry before retracting.
Troubleshooting
What is Happening? What Should Be Done?
Rub marks appear on
the fabric.
Check that there is no debris in the track where fabric goes into the case.
Fabric sags or is
loose.
Check tension on springs.
Make sure the end caps are properly secured.
Fabric will not roll up.
Check tension on springs.
Make sure there are no debris or foreign objects in the fabric opening or case.
Fabric will not unroll.
Make sure the pins that lock the tension for install have been removed from both
ends of the end caps.
If an optional anti-billow device is present, ensure that the device is properly
installed.
Fabric appears to roll
up at an angle.
Make sure the rail that is mounted to the unit is square with the main housing of
the slide topper.
Make sure fabric is cut square.

Lippert Components Solera Slide Topper Specifications

General

Brand	Lippert Components
Model	Solera Slide Topper
Category	Accessories
Language	English