Why won't my Lippert Components Accessories fabric unroll?
If the fabric of your Lippert Components Accessories won't unroll, ensure that the spring clips that lock the tension for install have been removed from both ends of the end caps.
What to do if Lippert Components Solera Slide Topper fabric will not roll up?
If the fabric of your Lippert Components Accessories won't roll up, check the tension on the springs. Also, make sure there are no debris or foreign objects in the fabric opening or case.
Why is Lippert Components Solera Slide Topper fabric sagging or loose?
If the fabric of your Lippert Components Accessories is sagging or loose, check the tension on the springs. Also, ensure that the end caps are properly secured.
How to fix Lippert Components Solera Slide Topper fabric rolling up at an angle?
If the fabric of your Lippert Components Accessories appears to roll up at an angle, make sure the rail that is mounted to the unit is square with the main housing of the slide topper. Also, make sure the fabric is cut square.
Position and secure the awning rail along the roof-wall meeting line or 3" above the slide room edge.
Slide extension rod into torsion arm, align fasteners, and secure with specified screw.
Prepare awning rail, feed polycord, attach extension rods, and center the slider.
Ensure fabric is square on roll tube and secure it in the awning rail with screws.
Extend awning to dry if wet, clean periodically with soap and water.
General| UV Protection | Yes |
|---|---|
| Water Resistance | Yes |
| Installation | Professional installation recommended |
| Category | Slide Topper |
| Material | Vinyl |
| Length Options | Varies by model |
| Compatibility | Compatible with most slide-outs |
| Operation | Manual |
| Fabric | Heavy-duty vinyl |
| Color | Black or White |
| Mounting Location | Above slide-out openings |
To Next Page
