EasyManuals Logo

Lippert Components Tire Linc Installation Manual

Lippert Components Tire Linc
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Rev: 02.24.20 Page 4 CCD-0001445
6. The programming is now complete and the receiver will start to scan for data from the tire sensors.
(Figs. 14, 15, 16, 17).
NOTE: If the Alternate Programming Method below is used, make sure to check the tire pressure to assure
the tires are properly inflated.
NOTE: When tires are rotated, the Tire Linc receiver (Fig. 6) must be re-programmed starting from Step 1.
Alternate Programming Method – Tire Linc Configuration by Deflation
NOTE: The procedure below replaces step number 5 of the standard programming procedure (see page 3)
only if the Tire Linc LF Initiator is unavailable. Step numbers 1 through 4 of the standard procedure
must be followed prior to beginning this procedure.
1. Go to the left front tire (roadside front) and release air from the tire by opening the valve. Deflate the
tire until the receiver (Fig. 6) displays “Config L REAR” (Fig. 11). Repeat process (releasing air from the tire)
to configure left rear tire (roadside rear). The receiver will then display “Config R FRONT” (Fig. 12). Repeat
process to configure right front tire (curbside front). The receiver will then display “Config R REAR” (Fig. 13).
Repeat process to configure right rear tire (curbside rear).
Fig. 14 Fig. 15
Fig. 16 Fig. 17
DISCONTINUED

Other manuals for Lippert Components Tire Linc

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lippert Components Tire Linc and is the answer not in the manual?

Lippert Components Tire Linc Specifications

General IconGeneral
BrandLippert Components
ModelTire Linc
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals