Rev: 10.18.21 Page 10 CCD-0004098
2. Raise a side patio panel assembly up into a 90 degree position (Fig. 15A) from the ramp door (Fig. 15B).
3. Locate the bungee on either side of the patio railing (Fig. 15C), which can be located higher or lower
on the outside rear of the patio railing closest to the door jamb (Fig. 15D).
A
E
D
C
C
Fig. 16
4. Place the hook of the bungee (Fig. 16E) onto the footman loop (Fig. 16D). Place the bungee and
footman loop onto the front of the door jamb (Fig. 16B) where a light tension can be felt in the bungee.
5. Mark the location of the bracket holes with a non permanent method of marking.
6. Install the footman loop onto the front of the door jamb with two OEM supplied self-drilling
screws (Fig. 16C).
7. Repeat steps 2-6 for the footman loop on the opposite side of the door jamb at the approximate same
location and height.
Fig. 15
C
C
A
B
D B D
A
B
To Next Page
Loading...