Lippert 3000 Series - Stowed Patio Position

Rev: 10.18.21 Page 24 CCD-0004098
Stowed Patio Position
If the Lippert 3000 Series ramp door is in the patio position and needs to be stowed, use the following
procedure.
1. Located on the middle front gate panel or the driver's side front panel for the no-gate option, unlatch the
U-shaped latch (Fig. 54A) by flipping the latch over towards the driver's side front patio railing (Fig. 55A).
2. Located towards the top of the ramp door, release the driver's side front panel bottom leg (Fig. 56A)
from the keeper (Fig. 56B) by pushing the compression latch lever (Fig. 56C) towards the coach and
slide the leg out from the keeper.
3. For the driver's side patio railing, swing the front panel and gate (Fig. 57A) or with the no-gate option
the driver's side front panel, out in-line with the side patio railing (Fig. 57B).
4. If applicable, disengage the J-lock (Fig. 3) on the driver's side of the patio railing.
Fig. 56
A
B
C
A
Fig. 57
B
A
A
Fig. 55
Fig. 54