Lippert 3000 Series - Stowed Ramp Position

Rev: 10.18.21 Page 21 CCD-0004098
Stowed Ramp Position
If the Lippert 3000 Series ramp door is in the ramp position and the ramp door needs to be stowed, use the
following procedure.
1. Release the rear bungee (Fig. 49A) attached to the bracket (Fig. 49B) on the door jamb (Fig. 49C) for
both sides of the patio rail kit and gently lower the patio railings to the surface of the door (Fig. 49D).
Fig. 49
B
Fig. 50
A/B
A
B
A
A
C
D
2. Attach the two snaps holding the front panel and gate to the driver's side railing (Fig. 50A) and the one
snap holding the front panel to the curbside railing (Fig. 50B).
NOTE: An alternate version of the patio rail kit has a, "no-gate" option, which there will only be one snap on
each side holding the two front panels to the side panels.