3
lippert.com 432-LIPPERT (432-547-7378) Rev: 08.22.22
Floë
838 Integrated
Water Drainage System
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004086
Fig.2
Fig.3
On/Off button
screw
cap
white
retainer
washer
screw
anti-vibration
washer
Fig.4
2. The shuto valve is a second safety valve and should be
used as a backup to the rst one-way safety valve built into
the tee.
3. If the air line needs to be installed horizontally to avoid
kinking, t the elbow joint (Fig.2) onto the air line stump on
the Floë box.
4. Then cut 2” o the air line to t onto the end of the elbow
and then onto one end of the shuto valve. (Fig.3).
NOTE: The longer air line will be connected to the shutoff
valve after the box is installed on the wall.
Attach Box to Wall
1. Locate a secure surface for installing the Floë box near
an AC outlet and also with access to the water main’s
shuto valve, either beside or near the unit.
NOTE: The On/Off button on top must be accessible.
NOTE: Toggle bolts or, if necessary, dry wall rawl plugs
can be used if installing the Floë box on drywall.
NOTE: It is not recommended to install the Floë unit on
an outside wall since it could create bumps on the outside
finish of RVs.
NOTE: Floë should be installed upright, not flat. Try to use a
corner, door jamb or cupboard to keep Floë straight and level.
2. Use an awl or punch to make indentations to start the
screws, beginning with the screws on the bottom of the
box.
3. Install white retainer washers on the screws and insert
screws through holes in the box tabs (Fig.4).
4. Then place anti-vibration washers on screws (Fig.4) and
fasten the box to the wall. Leave box loose to allow for
vertical adjustment.
5. Insert the top screws and washers into the tabs on the
Floë box and, after making nal adjustments, attach box to
the wall.
6. Tighten screws until the white retainer washers can no
longer move. Do not overtighten since that could crack the
green box tab.
7. Snap on black caps over the retainers on the screws.
To Next Page
Loading...